| SaveOnElectric.net Authorized Dealer |
| ORDER TOLL FREE 1-866-704-2427 |
INSTALLATION OF Power Save 3200 & Power Save 3400 UNITS
3 Phase Installation Information
Please have your Power Save unit installed by a licensed electrician!
Both 3200 & 3400 power save units have 4 wires exiting the bottom through a
¾” non-metallic connector.
Both Power Save 3200 & Power Save 3400 units can be installed as follows:
1. Using flex conduit and connector feed the 4 wires (3 red and 1 green) to
wire to the ground bar.
2. Using a fused or non-fused disconnect box interface unit into electrical
system
- When installing the PS 3200 use a 30 amp three pole breaker
- When installing the PS 3400 use a 40 amp three pole breaker
- In either method of install, and with both units, make certain the power
is off until the unit is installed completely, then turn power on (throw the
breaker on, or engage the disconnect box) and check to make certain
light is on.
- If light is not on, check breaker and disconnect box for secure
connections
- Either unit will work in a 208/480 environment
- For tech support call 1-800-955-2238
WARRANTY: The POWER-SAVE 1200 has a five year warranty from date of
installation. If you have a back-up generator, call support prior to installation, as
some generators are not compatible with the POWER-SAVE 1200
WARNING: HAVE YOUR POWER-SAVE UNIT INSTALLED BY A LICENSED
ELECTRICIAN. INSTALLING ELECTRICAL EQUIPMENT MAY RESULT IN
SHOCK, SERIOUS INJURY, OR EVEN DEATH
 |  |  |  |  |